wombat.ch

 just select
ssh Server
Standart Werkzeug

 apt install -y vim-nox

To enable SSH login for a root user on Debian Linux system you need to first configure SSH server. Open /etc/ssh/sshd_config and change the following line:
FROM:
#PermitRootLogin without-password
TO:
PermitRootLogin yes 

remove the #
reboot
ip addr

 first with nano /etc/ssh/sshd_config

To enable SSH login for a root user on Debian Linux system you need to first configure SSH server. Open /etc/ssh/sshd_config and change the following line:
FROM:
PermitRootLogin without-password
TO:
PermitRootLogin yes

# reboot

an Login with Traterm

#     apt full-upgrade

#    apt update -y && apt upgrade -y && apt autoremove 

#    apt install vim-nox -y

echo set number >> ~/.vimrc

echo syntax on >> ~/.vimrc

dpkg-reconfigure tzdata

echo This email address is being protected from spambots. You need JavaScript enabled to view it. >> ~/.forward

• CPU: AMD Embedded G series GX-412TC, 1 GHz quad Jaguar core with 64 bit and AES-NI support, 32K data + 32K instruction cache per core, shared 2MB L2 cache.
• DRAM: 2 or 4 GB DDR3-1333 DRAM
• Storage: Boot from m-SATA SSD, SD card (internal sdhci controller), or external USB. 1 SATA + power connector.
• 12V DC, about 6 to 12W depending on CPU load. Jack = 2.5 mm, center positive
• Connectivity: 2 or 3 Gigabit Ethernet channels (Intel i211AT on apu2b2, i210AT on apu2b4)
• I/O: DB9 serial port, 2 USB 3.0 external + + 2 USB 2.0 internal, three front panel LEDs, pushbutton
• Expansion: 2 miniPCI express (one with SIM socket), LPC bus, GPIO header, I2C bus, COM2 (3.3V RXD / TXD)
• Board size: 6 x 6" (152.4 x 152.4 mm) - same as apu1d, alix2d13 and wrap1e.
• Firmware: coreboot (please contact This email address is being protected from spambots. You need JavaScript enabled to view it. for source code if desired).
• Cooling: Conductive cooling from the CPU to the enclosure using a 3 mm alu heat spreader (included).